[aussiblue]

Australian Design Rules: http://www.infrastructure.gov.au/roa...dr_online.aspx http://www.infrastructure.gov.au/roa...dr_online.aspx http://www.infrastructure.gov.au/roa...ry-M-Group.pdf and http://www.comlaw.gov.au/Series/F2006L02745 with required approval marks

The approval mark shall consist of:

4.2.1. An international approval mark, comprising:

4.2.1.1. a circle surrounding the letter "E" followed by the distinguishing number of the country which has granted approval; 1/

4.2.1.2. the approval number prescribed in paragraph 4.1.3 above.

4.2.2. The following additional symbol or symbols:

4.2.2.1. On devices meeting the requirements of this Regulation in respect of the front position (side) lamps, the letter "A";

4.2.2.2. On devices meeting the requirements of this Regulation in respect of the rear position (side) lamps, the letter "R";

4.2.2.3. On devices meeting the requirements of this Regulation in respect of the stop-lamps, the letter "S" followed by the figure:

"1" when the device has one level of illumination;

"2" when the device has two levels of illumination;

"3" when the device meets the specific requirements for category S3 stop lamps.

4.2.2.4. On devices comprising both a rear position (side) lamp and a stop lamp meeting the requirements of this Regulation in respect of such lamps, the letters "R" and "S1" or "S2" as the case may be, separated by a horizontal dash;

4.2.2.5. On front or rear position lights of which the visibility angles are asymmetrical with regard to the reference axis in a horizontal direction, an arrow pointing towards the side on which the photometric specifications are met up to an angle of 80 degrees H;

4.2.2.6. On lamps which may be used as single lamps and as part of an assembly of lamps, the additional letter "D" to the right of the symbol mentioned in paragraphs 4.2.2.1 to 4.2.2.4;

4.2.3. The two digits of the approval number (at present 02 corresponding to the 02 series of amendments which entered into force on 5 May 1991) which indicate the series of amendments incorporating the most recent major technical amendments made to the Regulation at the time of issue of the approval and, if necessary, the required arrow may be marked close to the above additional symbols.