|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
04-03-2009, 06:18 PM
|
#1 | ||
|
FF.Com.Au Hardcore
 
Join Date: Nov 2007
Location: Riff
Posts: 12,406
|
howdy all,
In the middle of fitting a BA XR8 pod style air box.(to fill the gap) Do i- (a)- have a flanged plate to bolt upto old fixings, use small peice of hose and clamp off at each end or.. (b)- grind down sides of Mass Air Flow Sensor body and slip a 90mm silicon sleeve over it?? Opinions please. (also keep in mind i will not be going back to the original setup so returning to stock is not an option) 
__________________
FGII XR6 IN LIGHTNING STRIKE R52 SIII IN GUN METALLIC |
||
|
|
BA XR8 Air box dilema..
Threaded Mode